Adjusting spindle speed and feed rate

<< Click to Display Table of Contents >>

Navigation:  Interface > Tools Menu >

Adjusting spindle speed and feed rate

Adjust spindle speed

 

The Adjust spindle speed command is used to quickly change the spindle speeds in a CNC Program. If text is selected, it will add change the spindle speeds in the selected text. If no text is selected, the command will change the spindle speeds of either the entire file or the current line, depending on the user's preference. To change spindle speeds specify following parameters:

 

New value - type a new spindle speed value as a specific percent (100% - current value)

Minimum - Specify a value to make sure spindle speeds don't go below a minimum value.

Maximum - Specify a value to make sure spindle speeds don't go above a maximum value.

Decimals - Specify number of decimals to the right of the decimal point into this field.

 

Adjust feed rate

 

The Adjust feed rate command is used to quickly change the feed rates in a CNC Program. If text is selected, it will add change the feed rates in the selected text. If no text is selected, the command will change the feed rates of either the entire file or the current line, depending on the user's preference. To change feed rates specify following parameters:

 

New value - type a new feed rate as a specific percent (100% - current value)

Minimum - Specify a value to make sure feed rates don't go below a minimum value.

Maximum - Specify a value to make sure feed rates don't go above a maximum value.

Decimals - Specify number of decimals to the right of the decimal point into this field.